Momentum Modbus Plus 170 PNT Series Guide de l'utilisateur télécharger pdf (Page 22)

Assembling Adapter and I/O Base

870 USE 103 00 May 2001

Disassembling an Adapter from an I/O Base

Overview This section contains safety precautions and a procedure for disassembling an

adapter from an I/O base.

Tools Required A flat-head screw driver may be needed to disassemble the unit.

Disassembling

an Adapter from

an I/O Base

Follow the steps in the table below to remove an adapter from an I/O base.

CAUTION

ELECTRICAL CIRCUITRY MAY BE EXPOSED

Before removing an adapter from the base, disconnect the wiring

connectors. Make sure that the I/O base is not under power when it

does not have a Momentum adapter mounted on it.

Failure to observe this precaution can result in injury or

equipment damage.

Step Action

1 Choose a clean environment to disassemble the unit, in order to protect the

circuitry from contamination.

2 Make sure that the I/O base is not under power by removing the terminal

connectors from the I/O base.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Pas de commentaire

Momentum Modbus Plus 170 PNT Series Guide de l'utilisateur Page 22